Adjust Door Strike Plate

Move it away from the center if the strike will not seat when the door is closed.

Adjust door strike plate.

First shut the door and take a look at how far off the strike plate is in order for the latch barrel to align with the plate hole. The stripped hole repair kit from king s original ha. Latches that don t fit properly into these plates will allow doors to rattle or prevent them from closing. Then reinstall the plate with longer screws.

6 fill the gap between the strike plate and the door jamb with wood. Typically if you loosen both screws 1 2 full counterclockwise turns with your screwdriver or allen wrench the strike plate will be free to adjust. Gatehouse steel entry door strike plate. For minor adjustments you may be able to loosen the plate and tap it in the direction you need.

Find strike plates at lowe s today. If your filing action is shaking the strike plate remove the plate and secure it in a vise for your repair. For pricing and availability. Skip to main content.

Use a screwdriver to loosen the screws slightly. Screw the strike plate to the jamb then re bend the tab into the latch pocket by tapping it with a screwdriver and hammer. If it only misses by 1 8 inch or less the problem can likely be solved by tapping the plate in the right direction with a hammer. Turn the latch to draw in the bolt close the door and turn the latch again so the bolt hits the strike plate.

Reinstall the plate and test the dead bolt. Open the door and look for a telltale kiss on the strike plate. Thankfully the door latches and knobs don t have to be moved to correct these problems. Insert either a triangular file or a flat file that s small enough to fit inside the strike plate.

File off enough metal to allow the latch to catch inside the plate and secure the door. Find a store near me. Loosen the screws until the strike plate is free to move slightly. Adjust strike plates to close doors securely.

Have a door out of alignment due to settling. Unscrew the strike plate from the door jamb clamp it in a vise then file it down to the chalk mark above right. To snug the door up you would move the strike plate toward the center of the door jamb. The strike plate is the piece of door hardware that attaches to the door jamb and receives the latch.