Adding Soft Close To Existing Drawers

If the new screw holes don t line up you ll.

Adding soft close to existing drawers.

Hold the soft close attachment up to the top corner of the cabinet door so the flat edge sits behind the edge of the cabinet and the knob juts out just beyond the edge. Align the glide flush with the bottom of the drawer being sure the small extending part of the glide is positioned to the front of the drawer. Once both were in place you could try to slam the. Width and height of drawer.

Put the bit through the screw hole as you hold the soft close attachment in place. Step 2 drill a starter hole with a 3 32 inch drill bit attached to the electric drill. Place the new hinges into the mortises from the old hinges. Determine the size of the slides select a soft close side mount drawer slide.

If your slides are not mounted straight onto the cabinet. The easy way to update your drawers to make them soft closing is to install rockler soft close adapters to your existing epoxy coated slides and you don t have to replace the slides. One thing to note is to look at your drawer ours has metal sides that. Even though drawers are harder than the cabinets it still only took about 2 hours to do all of the drawers in our kitchen.

Line up the plastic piece that goes onto the outside of the drawer itself. Install drawer glides place the drawer on its side. The good thing is retrofitting your kitchen for soft close drawers is much cheaper than getting new ones and the parts are very inexpensive. Unscrew the hinges from the cabinet doors using the screwdriver.

Well if you ve ever wished for quieter closing drawers. Width and height of drawer opening. For under mounts clearance between the drawer bottom and the side of the drawer fortunately 90 of drawers that aren t soft close have a 1 2 gap on each drawer slide. Instructions line up the slow close rods exactly with the drawer slides.

The soft close feature will slow the closing action and gently pull the drawer closed. Converting existing drawers to soft close slides starts with a few basic measurements. Let s take a look at the basic steps. Unscrew the existing drawer glide hardware from both the drawer and the cabinet.

Retrofit soft close to almost any drawer blumotion. 9 minimum drawer depth. Make sure it lines up with the rod. As long as you have a 1 2 gap on either side of the existing drawer you should be able to do a side mount soft close upgrade.

Using the screwdriver unscrew the hinges holding the cabinet doors to the cabinet and remove the doors. Easily add the soft close feature to any wood or malamine drawer with a 1 2 side clearance.