Adding Baseboard To Floor With Carpet

When this carpet is removed and replaced with hardwood vinyl or other floor coverings you might spot a gap between the bottom of your baseboards and your new floor.

Adding baseboard to floor with carpet.

Adding moulding to your home or office adds value and a nice finishing touch. There are two reasons for this gap which is generally required by building codes. Try adding painters tape over the baseboard for protection. Place the baseboard on the wall.

Two baseboard pieces cut at matching angles can be joined together at inside and. Take a carpenter s level and place it over the board. Enhance the areas where floor and wall meet enhance the areas where floor and wall meet with the colonial 8 ft. If you plan to install baseboard moulding before adding carpet it needs to be installed 1 inch above floor level to allow room for both pad and carpet.

But depending on the cost of molding it may just be more cost effective to trade out the old baseboards with new and taller ones. Then just fill all the cracks with caulk. However when installing the baseboard later painting and applying caulk can be a more tedious task to avoid mixing it in the carpet. To place the baseboard properly keep one fourth inches of space between the baseboard and the surface of the floor.

When glue doesn t secure the carpet tack strips installed on the floor near the wall hold the carpeting down. When installing baseboards after carpet. Carpet installers often tuck the ends of the carpet under the baseboards for a clean finished look. Pvc base moulding.

If adding baseboards after carpet is laid it should be installed at the same height as without carpet. The baseboard at the bottom of a wall should always be installed slightly raised from the floor s surface. Base moulidng can hide gaps and protect walls from traffic and floor maintenance. With the help of the carpenter s level make sure that the baseboard is placed in the right way.

Baseboard trim has nothing to do with holding carpeting in place. Professional looking baseboard installation can be achieved with a compound miter saw that can cut 45 degree corner angles at the molding ends. If you are not intending to install quarter round or base shoe the baseboard should be.