Large splinters of wood can be glued with a wood glue.
Add moisture to wood.
Displaystyle text moisture content frac m text g m text od m text od times 100 here m g.
Make sure they re aligned with the grain and not across it.
Collect your wood and stack it loosely.
Pin type moisture meters insert the pins into the surface of the wood you want to test.
So heating air will cause shrinkage in wood because the humidity drops not because of the heat.
The glue creates a binder that holds the material together for filling in small holes and cracks in wood.
The filler is kept moist either with water or solvents.
Use wooden pegs and drilling.
Seal off the bare wood and paint using a matte finish spar urathane that will hold up to moisture wet area use or a flat finish varnish.
Turn on the meter.
A year or more would be better.
1 tablespoon lemon juice.
Clean off the dust with compressed air.
The sap in the tree creates creosote when it burns.
One way to tell the difference is to open the can and smell.
Cover it or stack under a shed where the air can circulate over and around it.
Water based fillers do not have a strong chemical odor.
1 tablespoon olive oil.
Remove any peeling paint with a scraper.
Moisture content is measured with a moisture meter.
Wood filler is basically a mixture of glue and gypsum or sawdust.
For more info on meters go to.
Dip the corner of a rag into the mixture and then rub it into the wood.
Other uses may require air dried or green wood with a higher moisture content.
You can use a very fine grit sandpaper or sanding sponge to smooth out the bare wood.
Get a good quality furniture oil for light wood it should be about the color of honey.
The electrical current will then move from pin to pin and measure the resistance encountered.
Combine all three ingredients in a small bowl stirring well to get everything mixed together.
Green wood wood cut this year from live trees with leaves on them should dry for at least several months in the stacks.
Kiln dried wood is usually in the 6 8 range which is ideal for turning and furniture building.
That is if we heat the air 25f hotter and add moisture to keep the rh at 100 percent rh there.
The moisture content of wood is calculated as the mass change as a proportion of the dry mass by the formula siau 1984.
Oil it and let it soak in for a month.
Moisture is not the problem.